How to fix small dents in aluminum siding drill a hole in it insert a sheet metal screw tug the washer putty the hole sand the spot prime and paint the repair.
Getting dents out of aluminum siding.
Wipe down the aluminum trailer s dent to get it moist.
Drill a small hole into the middle of the dented area of the aluminum siding.
Hammer off dolly for stress relieving is the best technique to avoid stretching aluminum.
Work slowly and stop the drill before.
Place a flat washer onto a sheet metal screw and then screw it part of the way into one of the holes you drilled.
Push a metal screw into the hole far enough so that it becomes difficult to turn.
Using sandpaper take off all the paint.
Repairing small dents 1.
It doesn t take a lot.
How to repair a dent in an enclosed aluminum trailer step 1.
Specially designed suction devices are sold in car repair stores for this purpose.
Braising is totally different and anyone can do it with the proper aluminum braising rods.
Use pliers to pull the dent halfway up.
Play pause space step 2.
Screw the 6 self tapping screw into the center of the dent.
Pull back on the plunger to straighten the dent.
Sanding sponges work.
Hopefully the dent will pop out and the siding will be.
Hammering will leave hammer marks but if your really good at it you might be able to hammer it out and have it look decent.
Kirkham university aluminum fender dent repair duration.
Using boiling water to get car dents out duration.
Don t use just any braising rod.
Place a plunger against the dent and push down to create suction.
Do not weld on aluminum unless you have had proper aluminum welding training.
Use caution if you are standing on a ladder.
Dampen a rag in water.
David kirkham 317 053 views.
You want it where it s deepest.
Here s what to do.
Drill a couple of 1 8 inch holes in the part of the siding that contains the dent.
Very large dents can be fixed by actually pulling the dent into line with the rest of the sheet metal.
Slapping spoons and other techniques are also good ways to relieve stress and not damage the metal.
Grip the head of the metal screw with.
