September 1 2009 at 12 07 pm hi carole what type of carpeting are you thinking about.
Glue down carpet and pad.
Here are some alternative methods to get carpet glue off of concrete that will protect your health and your wallet.
Pads extend the life of the carpet.
Allow pad to sit 10 minutes to dry.
Is it better to glue carpet down or use padding in a commercial environment.
Use boiling water to soften the glue.
Press down firmly with your hands to secure.
Simply boil some water and pour it carefully over the carpet glue in sections.
When one strip of carpet pad is completed move on to the next strip.
Step 1 scraping the carpet glue.
This method combines the stability of direct glue down carpet with the cushioning benefits of a separate cushion stretch in installation as outlined below.
Hot water will make the glue come to a softer state.
Carpet comes up easy.
The foundation is all concrete.
The heat will soften the glue and as it is doing so scrape it off using your handy razor blade scraper.
The scraper can easily remove big chunks of the glue which helps get the job done more easily later.
Pulling up the carpet and scraping underneath with a paint scraper to beak the glue bond is tedious work and wetting the carpet to loosen the adhesive may cause it to break into pieces.
Simplifies carpet bordering and inlaying.
Trying to pull it up just results in ripping off a little bit leaving some of it glued to the floor.
Going to tear up the carpet pad and put in hardwood.
Apply glue to another section of the floor and unroll the carpet pad onto the new glue.
Step 6 continue applying glue and unrolling the carpet pad until the entire pad is glued down.
It s not a good idea to go without using a carpet pad.
Remove as much of the carpet glue as possible by scraping it using a razor blade scraper.
Carpet installers use strong mastic that doesn t deteriorate when they glue down carpets and they often use more than is really needed both of which spell bad news for you when you want to remove the carpet.
Suitable for wheeled traffic areas.
Let the hot water penetrate for about 2 minutes.